Magnaflow MITSUBISHI LANCER Stainless Cat-Back System PERFOR User Manual download pdf

Step 1: (Carefully read all instructions before

installation) Remove the OEM system by unbolting

the flange located behind the catalytic converter and

the flange located near the muffler inlet. Carefully

remove the OEM system making sure not to damage

any of the original mounting hardware or rubber

isolators, as they will be needed to install your new

MAGNAFLOW system.

Step 2: Attach the Inlet Pipe Assembly at the flange

junction using the OEM fasteners. Working front to

rear install the rest of the new system by locating the

hangers into the appropriate OEM isolator and by

using the supplied clamps.

Step 3: With all components mounted loosely, adjust

the system for overall aesthetics and clearance of

frame & bodywork. (MAGNAFLOW recommends at

least 1/2" of clearance between the exhaust system

and any body panels to prevent heat-related body

damage or fire.)

Step 4: Once a final position has been chosen for the

new system, evenly tighten all fasteners from front to

rear. The supplied band clamps must be VERY tight

to properly align the pipes and prevent leaks

(Approximately 65ft-lbs). U-bolt clamps should be

tightened to approximately 30-35ft-lbs. inspect all

fasteners after 25-50 miles of operation and retighten

if necessary.

Mufflers, Converters,

Systems and Tips

INSTALLATION INSTRUCTIONS

15597

2009 Mitsubishi Lancer Ralliart 2.0L

Warning: When working on, under, or around

any vehicle exercise caution. Please allow the

vehicle's exhaust system to cool before removal,

as exhaust system temperatures may cause

severe burns. If working without a lift, always

consult vehicle manual for correct lifting

specifications. Always wear safety glasses and

ensure a safe work area. Serious injury or death

could occur if safety measures are not followed.

** Magnaflow Performance Exhaust recommends professional

installation on all their products

Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688

Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500

Sep 13, 2010

Rev: 000

Inlet Pipe

Mid-Pipe

Muffler

Assembly

2X 3.00"

Clamp

INSTALLATION INSTRUCTIONS 1

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Step 1: (Carefully read all instructions before installation) Remove the OEM system by unbolting the flange located behind the catalytic converter an

Comments to this Manuals

No comments

Magnaflow MITSUBISHI LANCER Stainless Cat-Back System PERFOR User Manual

Browse online or download User Manual for For the car Magnaflow MITSUBISHI LANCER Stainless Cat-Back System PERFOR. MagnaFlow MITSUBISHI LANCER Stainless Cat-Back System PERFORMANCE EXHAUST User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Magnaflow MITSUBISHI LANCER Stainless Cat-Back System PERFOR