Magnaflow DODGE CHARGER R/T HEMI Stainless Cat-Back System P User Manual download pdf

Mufflers, Converters,

Systems and Tips

2011 Dodge Charger R/T 5.7L

Warning: When working on, under, or around

any vehicle exercise caution. Please allow the

vehicle's exhaust system to cool before removal,

as exhaust system temperatures may cause

severe burns. If working without a lift, always

consult vehicle manual for correct lifting

specifications. Always wear safety glasses and

ensure a safe work area. Serious injury or death

could occur if safety measures are not followed.

** Magnaflow Performance Exhaust recommends professional

installation on all their products

Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA

92688

Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500

05/20/11

Rev: 000

Step 1: (Carefully read all instructions before

installation) Remove the OEM system by

loosening all the assembly clamps. Remove the

muffler assemblies making sure you retain all the

OEM mounting hardware and rubber insulators

as they will be used to install your new

MAGNAFLOW system.

Step 2: Begin installation of the new system by

fastening the (2) Inlet pipes to the catalytic

converter extensions using the supplied 2.25"

clamps. Leave all clamps and fasteners loose for

final adjustment of the complete system. Install

the Tru-X/ Resonator Assembly using the

supplied 2.50" clamps and by fitting the welded

hangers into the OEM rubber insulators. Install

the Driver and Passenger Muffler Assemblies in

a similar fashion.

Step 3: With all components mounted loosely,

adjust the system for overall aesthetics and

clearance of frame & bodywork.

(MAGNAFLOW recommends at least 1/2" of

clearance between the exhaust system and any

body panels to prevent heat-related body damage

or fire.)

Step 4: Once a final position has been chosen for

the new system, evenly tighten all fasteners from

front to rear. The supplied band clamps must be

VERY tight to properly align the pipes and

prevent leaks (approximately 40ft-lbs). U-bolt

clamps should be tightened to approximately 30

- 35ft-lbs. Inspect all fasteners after 25-50 miles

of operation and retighten if necessary.

INSTALLATION INSTRUCTIONS

FOR 15493

X-PIPE RESOATOR

SUB ASSY

P/S INLET PIPE

D/S INLET PIPE

D/S MUFFLER ASSY

P/S MUFFLER

ASSY

Summary of Contents

Page 1 - FOR 15493

Mufflers, Converters, Systems and Tips2011 Dodge Charger R/T 5.7LWarning: When working on, under, or around any vehicle exercise caution. Please allow

Comments to this Manuals

No comments

Magnaflow DODGE CHARGER R/T HEMI Stainless Cat-Back System P User Manual

Browse online or download User Manual for For the car Magnaflow DODGE CHARGER R/T HEMI Stainless Cat-Back System P. MagnaFlow DODGE CHARGER R/T HEMI Stainless Cat-Back System PERFORMANCE EXHAUST User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Magnaflow DODGE CHARGER R/T HEMI Stainless Cat-Back System P